Ormsby Goliath 7
Neck
Material: Maple, headless
Fretboard: Ebony
Scale Length: 25.5"-27.8" multiscale
Fretboard Radius: 16"
Fret Size: Jumbo
Fret Material: Stainless steel
Nut: Graphtech Black TUSQ XL
Neck Finish: Clear satin
Body
Material: Black limba
Body Finish: 'Bloodbath' (trans black to red fade over flame maple)
Hardware
Machine Heads: N/A
Bridge: Ormsby headless
Hardware Finish: Black
Setup Spec
Tuning: Drop F#
Strings: Winspear 11-80
Neck Relief: 0.25mm
Action at 17th Fret
Bass Side: 1.8mm
Treble Side: 1.15mm
Pickups
Bridge
Brand: Ormsby Custom Shop
Model: Toe Cutter
Output: 14.8kΩ
Magnet: Ceramic VIII
Neck
Brand: Ormsby Custom Shop
Model: Hybrid+
Output: 14kΩ
Magnet: AlNiCo V
Electronics
Control Layout: Volume, push/pull tone, 3-way switch
Selector Switch: Oak Grigsby 3-way super switch
Potentiometers: CTS 500kΩ, Bourns 500kΩ p/p
Tone Capacitor: 0.015uF paper-in-oil
Output Jack: PureTone Full Contact
Switching
Position 1: Bridge
Position 2: Outer coils (parallel) (PRS partial split*)
Position 3: Neck
Push/Pull: Engages tone circuit, bypassed by default
*Unlike a traditional coil split, which fully grounds one of the coils of the humbucker, the PRS partial split uses a resistor (2.2kΩ bridge and 1.1kΩ neck) to only partially ground the coil. This results in less of a volume drop going to the 'single coil' mode and also means there is still some hum-cancelation too.